The objectives of this study were to make yoghurt from camel milk and determine its physicochemical, microbiological and sensory qualities. The quality of camel milk yoghurt was compared with cow milk yoghurt and all parameters were analyzed following standard procedures. Yoghurt of acceptable consistency was made from camel milk using 1.2% gelatin, 5% bovine skim milk powder, 1.5 ml/L of calcium chloride, 40 ml/L of maple strawberry syrup and 6% yoghurt culture (YF-L811) and by incubating the milk at 42°C for 18 h. The average values for moisture, ash, syneresis, pH, titratable acidity and total solids of camel milk yoghurt were 83.4%, 1.13%, 58%, 4.37, 1.255% lactic acid and 16.7%, respectively. The corresponding values for cow milk yoghurt were 80.6%, 0.71%, 56%, 4.67, 0.865% lactic acid and 19.5%, respectively. The titratable acidity of camel milk yoghurt was significantly higher (P<0.05) than cow milk yoghurt; however, no significant difference was observed between the two yoghurt types for the other parameters. Coliforms were not detected in both yoghurt types. The sensory analysis showed that cow milk yoghurt was more preferred by the panellists than camel milk yoghurt. Production of yoghurt from camel milk using the same procedure as for cow milk yoghurt proved to be difficult.  Further research is called for to improve the acceptability of camel milk yoghurt using locally available and acceptable flavouring agents. Research needs to be conducted to optimize the operating parameters and standardize the production procedures of camel milk yoghurt in the future.

The purpose of this study was to investigate optimum test conditions of acoustical-mechanical measurement of wafer analysed by Acoustic Envelope Detector attached to the Texture Analyser. Forcedisplacement and acoustic signals were simultaneously recorded applying two different methods (3-point bending and cutting test). In order to study acoustical-mechanical behaviour of wafers, the parameters “maximum sound pressure”, “total count peaks” and “mean sound value” were used and optimal test conditions of microphone position and test speed were examined. With a microphone position of 45° angle and 1 cm distance and at a low test speed of 0.5 mm/s wafers of different quality could be distinguished best. The angle of microphone did not have significant effect on acoustic results and the nu

In humans, food oral processing (FOP) is the first step in the digestive process. It prepares the food for swallowing and to undergo the process of digestion. During chewing, the food is comminuted by the combined action of chewing and saliva to form a bolus. The particle size of the bolus is reduced due to the action of the tongue and the teeth, and the saliva is continuously produced by the salivary glands to humidify and impregnate the food. Saliva lubricates the bolus and enables the cohesion of particles to prepare for swallowing. During food oral processing, the compounds responsible for food flavour and taste are released, leading to the perception of food organoleptic properties and significantly contributing to the consumer’s acceptability of the product. Understanding this process of food breakdown and bolus formation thus appears to be a way to revisit food functional properties. However, this process is extremely complex, and as such, its description necessitates a combination of many quantities from different disciplines, i.e., physics, chemistry, physiology, psychology, behavioural science and food science. It depends, on one hand, on food properties and on the other hand, it depends on oral physiology. However, large inter-individual variability is commonly observed, which has important consequences on flavour release and perception. The challenge for the food industry is to be able to develop food considering this large variability, and sensory and nutritional constraints. This challenge is particularly relevant when specific populations (i.e., elderly, infants or obese subjects) are considered.

This study employs the logit model to assess the determinants of consumers’ willingness to consume cassava leaves as a leafy vegetable in the Kumasi Metropolis of Ghana. A multistage sampling technique was used to select 180 respondents for the study. The study found that majority (76%) of the respondents had no knowledge of the nutritional value of cassava leaves, though they had consumed the product before. The empirical results showed that socioeconomic characteristics of respondents such as age, sex, household size and monthly income, as well as their perceptions on the attributes and use of cassava leaves as food have significant influence on willingness to consume cassava leaves as a leafy vegetable. There is the need to provide information on the nutritional benefits of cassava leaves to facilitate decision-making on its utilisation/consumption. Programmes aimed at promoting the consumption of cassava leaves should consider the significant variables that have influence on the consumption of the product.

The objective of this work was to investigate the potential use of pulsed electric field (PEF) in combination with osmotic dehydration (OD) as a pre-freezing step and to evaluate the effect on quality characteristics and shelf life of frozen kiwifruit. Peeled kiwifruit was subjected to PEF (1.8 kV/cm), sliced and treated in OD-solution (containing glycerol, maltodextrin, trehalose, ascorbic acid, calcium chloride, citric acid, sodium chloride; 1/5 (wfruit/wsolution)) for 30 and 60 min at 35 °C. Combined, PEF only and OD only treated samples as well as nontreated and blanched (80 °C, 60 s) samples were frozen and stored at constant (-5, -10, -15, -25 °C) and dynamic temperature conditions (-18 °C-3 d, -8 °C-2.5 d, -15 °C-3 d). Quality of frozen samples was evaluated by means of drip loss, colour, texture, vitamin C and sensory evaluation (1-9 scale); and shelf life (SL) was calculated. Nontreated and blanched samples presented high drip loss and tissue softening (instrumentally measured as Fmax decrease). The tissue integrity was well retained in all osmotically pretreated samples. PEF pretreatment caused increase of fruit whiteness (increase of L value) and yellowness (a and/or b value increase); SL calculation was based on colour change. All OD samples had high vitamin content (24.6 mg/100 g fresh material compared to 138-154 mg/100 g osmodehydrated material); PEF led to 93% (of the initial) vitamin retention; blanched samples showed the lowest retention (86.9% of the initial) (criteria for SL calculation). OD and combined PEF-OD treatment increased the shelf life of frozen kiwifruit (up to 3 times; based on sensorial criteria). The developed kinetic models for colour change, vitamin loss, and sensory quality deterioration were validated at dynamic temperature conditions. PEF pretreated OD (at significantly shorter time, 30 min compared to 60 min) kiwifruits retained optimum quality and sensory characteristics. PEF and OD could be used as a preprocessing step of good quality, longer shelf life kiwi sliced frozen products.

What is the profile of Food Engineering education in Brazil? Are we following the contemporary professional renewal trend? Driven by these questions, the present study analyzed data regarding 21 academic courses, which represent approximately 22% of the total bachelor’s degree in food engineering courses offered in the country. Samples were defined considering a Brazilian annual ranking of undergraduate programs: very good (four stars) and excellent (five stars). Next, information was recovered from both the Brazilian Ministry of Education and institutional homepages of each analyzed program. The results suggest that food engineering programs exhibit relative identity, naturally due to their history and the path of each program and their faculty, shaping particularities in how fields of knowledge are constituted, in addition to their representativeness in the total workload of the program. However, initial analysis is suggestive regarding understanding that Brazil is not properly doing its homework, based on global movement, concerning food engineering education. The need to rethink Brazilian technical education, without culminating in additional workload, is emphasized, not only regarding new materials and technologies for learning and teaching, but also in terms of bringing a human and market approach. The achievement of this complex goal seems to be provided by the encouragement of student associations, transversal learning processes, and learning experiences outside the classroom as a means of improving undergraduate programs and human resources.

The objectives were to evaluate the properties of refined (ROO) and extra-virgin olive oil (EVOO) in their natural state (fresh) and after heating, while comparing them with each other and with refined soybean (SBO) and refined sunflower seed oil (SFO). The methodology was designed to simulate, in controlled laboratory conditions, the home-frying process, while evaluating fatty acid profile (fatty acid methyl esters were separated by gas chromatography), concentration of phenolic compounds (Gallic acid dosage), antioxidant activity (DPPH), and production of polar compounds (thin layer chromatography) before and after heating to 200 °C for six minutes. It was observed that, before and after heating, SBO and SFO are rich in polyunsaturated fatty acids (FA) and ROO and EVOO are rich in monounsaturated FA. Fresh or heated, ROO and EVOO do not have trans FA, which are present in SBO and SFO, and increase in SBO after heating (+ 32.8%). The concentrations of phenolic compounds are always higher in olive oils, despite the decrease that occurs after heating (-7.5% in the ROO and -24.6% in EVOO). Antioxidant activity is greater when olive oils are fresh and remains present in EVOO after heating. The concentration of polar compounds was similar for all oils after heating. In conclusion, ROO and EVOO are the richest in monounsaturated FA even after heating, with no production of saturated or trans FA. Despite losing some antioxidant activity, heated EVOO remains richer in monounsaturated FA than ROO, SBO and SFO in the fresh version. All oils suffer similar rates of degradation.