This research aims to examine the effects of fermentation time on the physicochemical and sensory characteristics of green coconut water kefir in order to determine the optimal fermentation time based on the resulting sensory attributes. There were four fermentation time treatments (12, 24, 36, and 48 hours), each with five replications. The materials used were green coconut water and 5% kefir grains. Physical analyses included pH and viscosity, while the chemical analyses included total dissolved solids (TDS), alcohol content, water content, protein content and fat content. Sensory attributes included sourness, soda sensation, sour aroma, viscosity and turbidity. The results showed that fermentation time had significant effects on pH, TDS, alcohol content, water content, protein content and the sensory attributes of green coconut water kefir. Viscosity and fat content were not affected by fermentation time. The ideal fermentation time was 12 hours resulting in a pH level of 4.6, viscosity of 0.09, TDS of 3.8° Brix, alcohol content of 1.16%, water content of 97.14 %, protein content of 6.64 % and fat content of 1.17%. Sensory evaluation found a low level of sourness, low soda sensation, high sour aroma, high viscosity and low turbidity.

This study compared, for the first time, the postharvest conservative action of edible fungal chitosan coatings (gel, nanoparticles and gel-nanoparticle) on the physico-chemical, sensorial and microbiological characteristics of strawberries. The nanoparticles were prepared by an ionic gelation method and characterized by dynamic light scattering and scanning electron microscopy. The antioxidant (DPPH* and ABTS*) activity of the edible coatings and the antimicrobial (macrodilution method) action against phytopathogenic fungi were verified. The nanoparticles had a size of 331.1 nm and a zeta potential of+ 34 mV. The gel, nanoparticles and gel+nanoparticles exhibited minimum inhibitory concentration values ranging from 4 to 5, 1.5 to 2.5 and 1.0 + 0.5 to 2.0 + 1.5 g.L-1, respectively. All the edible coatings exhibited antifungal action. All the coatings had high scavenging activity, especially the gel edible coating. The coatings, especially the gel+nanoparticles, decreased the weight loss, microbiological growth, soluble solids, maturity index and moisture loss of the strawberry and preserved the pH values, anthocyanin content, titratable acidity and sensory characteristics. Therefore, the use of chitosan edible coating containing nanoparticles can be a promising strategy to improve the post-harvest quality of strawberries.

In this work, the exposure of people, through their diet, to polycyclic aromatic hydrocarbons (PAHs) has been assessed for the urban, rural, and general populations in Syria. The food categories consumed have been divided into major groups, and the health risk assessment on dietary exposure of PAHs determined in each food category. For this purpose, two approaches were used: incremental lifetime cancer risk (ILCR) and margin of exposure approach (MOE). The results showed that each of the following food categories: oils and fats, meat and meat products, vegetables, and cereals dominantly contribute in the dietary exposure of PAHs. Also their MOE values are the lowest. Additionally, they have higher ILCR values. Therefore, these groups are a main risk source to health. On the other hand, the dietary exposure of PAHs in each of urban, rural and general populations was of low health concern, whereas their ILCR values reached to 10E-05 in total food categories, nevertheless it remains lower than serious risk level (ILCR>10E-04). This work is the first study that is dealing with dietary exposure of PAHs and their health risk assessment in Syria.

Noodle consumption has been increasing in Nigeria as a result of rapid urbanization, increase in population growth, and desire for convenience food. Noodles are produced from wheat our which is not grown in Nigeria. In order to reduce wheat imports and improve utilization of local crops, various options have been developed to replace wheat flour partially or wholly in noodle production. This study was aimed at optimizing the level of major ingredients to obtain the best flour blend for noodle preparation with optimum nutritional quality. Pro-vitamin A cassava roots (Manihot esculenta Crantz) and African yam bean seeds (AYB) (Sphenostylis stenocarpa) were processed into ours. The ranges of these flours, based on preliminary findings, were computed into a central composite design of Response Surface Methodology (RSM) to obtain 13 flour blends with five central points. The chemical compositions, anti-nutritional factors, and pasting properties of these flour blends were analyzed and measured. By maximizing total β-carotene, protein content, and minimizing fat content, the predicted model indicated the optimum blend of 70.52% cassava flour to 29.48% AYB flour. The best our blend sample of 69.23% cassava our to 30.77% AYB flour gave the actual value of total β-carotene 6.76 μg/g, with proximate analysis composition of protein 6.17%, fat 0.82%, moisture 8.95%, ash 1.77%, crude fiber 5.09%, and carbohydrate 82.30%. The anti-nutritional factors of the best blend were 8.21 mg HCNeqv/kg, 1.69 mg phytate/g and 0.37 mg tannin/g.

The aim of this study was to enhance the nutritional value and the functional characteristics of muffins by enriching with chickpea protein isolate, while keeping their rheological characteristics. Chickpea Protein isolate (CPI) was prepared by alkaline solubilization (pH 11), followed by isoelectric precipitation at pH 4.5. SDS-PAGE revealed three subunits with molecular weights of 47, 30 and 85 kDa; representing the globulin fractions, legumin-like and vicilin-like proteins. Maximum protein solubility (83.32%) was obtained at pH 11. CPI exhibited an emulsifying activity index of 25.17 m2 g-1, emulsion stability index of 14.09 min. The foaming capacity and stability were 62% and 94.49%, respectively. Water and oil absorption were 3.65 and 2.30 mL g-1, respectively. CPI was added to muffin batter at 0, 2.5, 5, 7.5 and 10%. CPI fortifieded muffins showed reduction in moisture content, which influenced texture profile analysis through increasing hardness, gumminess and chewiness values. Additionally, both protein content and protein digestibility of muffins increased to 22.2 and 94.08%, respectively. CPI-enriched muffins were darker (lower L) with yellowish crumbs (higher b). Finally, preliminary sensory evaluation showed high consumer acceptance for CPI-enriched muffins.

This work examined the relationships between quality characteristics of raw milk and climatic conditions. Over a period of three years, a total of 5,065 samples were collected encompassing two types of farms. The quality characteristics analysed were titratable acidity (TA), total plate count (TPC) and somatic cells count (SCC). Climatic conditions were evaluated in respect to the outdoor air temperature, pressure, humidity and precipitation. Big farms showed a stronger correlation between TA and climatic conditions as opposed to SCC and climatic conditions. TPC was out of limit in big farms when the outdoor air temperature was higher than 19.8 °C (p<0.05) and during periods with accumulated precipitation over 4.2 mm (p>0.05). Small farms showed a stronger correlation between SCC and climatic conditions as opposed to TA. In these farms, occurrence of acidity out of limit was detected in less than 7.2% of samples. Samples with TA out of limit were observed when air temperature was higher than 18.4 °C (p<0.05) and accumulated precipitation was below 3.1 mm (p>0.05). These results can be used to improve good agricultural practices in respect to climatic conditions and size of farms.

Imported rice is perceived to have better cooking properties than locally grown rice in Nigeria and it has increased its market share while reducing patronage for local rice. Rice in Nigeria has many applications, including consumption as whole cooked grain or dumpling or use as an adjunct in making beverages. Eighteen varieties of parboiled milled local rice and three imported rice varieties, coded Ip1, Ip2 and Ip3, were studied for their cooking and functional properties using standard methods. There was a significant (p<0.05) increase in the dimensions of all the rice varieties when cooked. There was a 25 g increase in the grain weight and an elongation ratio of more than 1.26 in all the rice varieties. Ghesua had the highest cooked grain weight (68.67 g) while Omor-Mas (6.00) and R-Bus (6.00) had the highest volume expansion ratio (VER). The VER was more than 3.00 for all the rice varieties. All the local rice varieties imbibed less water (17.67-25.33 ml) compared to the imported rice varieties (26.00-27.67ml) before they reached their optimum cooking time. The imported rice varieties were of soft gel consistency (89.67-73.50 mm) and intermediate amylose content (20.71-23.14 %) while the local rice varied in amylose and gel consistency. Abakiliki-Mas (27.00 mm) and R-8 (33.67 mm) were of hard gel-consistency, intermediate (21.11 %) and high amylose (27.21 %) content respectively and have not been exploited although they would be appropriate for making canned rice, dry mixes and rice-noodles.

Food is a necessity of human beings, and the consumption of food is aimed at obtaining energy and nutrients necessary for the growth and proper functioning of the body. However, food can also be a vehicle for various diseases, and the causal agents can have physical, chemical or biological origin with relevance to health due to their incidence, mortality and negative consequences in the population. Bacteria are the main agents of biological origin associated with foodborne diseases. Among these microorganisms are species of the genus Campylobacter, which cause a zoonosis with one of the highest incidences globally, known as Campylobacteriosis. This document provides an overview of foodborne diseases, specifically the causal agents of Campylobacteriosis, including the different measures of control and prevention for this disease in different foods such as poultry, milk, meat, and fish, among others. It also covers the phenomenon of resistance to antimicrobials by these pathogens and the health implications to consumers. The above can generate and maintain safety practices in food production for the protection of public health in different regions around the world.

Currently, improvement of food preservation has been a substantial challenge for industries to increase shelf-life of products and to maintain food quality during storage. These goals are often tied to the sustainable tendency for use of eco-friendly packaging to store these products without loss of the packaging features. Therefore, the aim of this study was to produce biodegradable antimicrobial films by the incorporation of nisin Z peptide under different concentrations (0 %, 5 %, 10 %, 15 % and 20 % wt.) into hydroxypropylmethylcellulose (HPMC) matrices. The active film properties were evaluated in terms of their antimicrobial capacity in vitro, mechanical performance and microscopic characteristics. Hence, active films containing 10 % (wt.) of nisin Z and control films were placed in contact with sliced mozzarella cheese for eight days, and microbiological growth was monitored during storage. Nisin Z’s antimicrobial effects were observed against the Gram-positive microorganisms such as Staphylococcus aureus and Listeria innocua, regardless if the compound was free as a suspension or incorporated into HPMC matrices. However, the expected low action of nisin Z against Gram-negative bacteria, as reported in literature, was not observed since Salmonella enterica Choleraesuis’s growth was inhibited. Moreover, active films with added nisin Z (10 % wt.) were more effective than the control film to inhibit mesophilic microorganisms in mozzarella cheese during 8 days of storage. The mechanical properties of the films were not influenced by nisin Z incorporation, since the addition of the compound enhanced the active function without the loss of mechanical properties required for a good food packaging. These results suggest that biodegradable films produced by nisin Z addition into HPMC matrix are an excellent biomaterial for mozzarella cheese preservation.

This paper focuses on research, development, and capacity building in relation to food and nutrition security (FNS) in sub-Saharan Africa (SSA). It looks at human capacity, education, teaching and learning, women empowerment, research, innovation and technology, research, indigenous knowledge (IK), institutional aspects, infrastructure, information and communication technologies (ICT), policies and finance. Professional bodies exist in many countries and the extent to which they engage in FNS awareness creation differs. Food and nutrition insecurity continues to affect people in Africa’s 54 nations where the population is expected to double by 2050 with the expected doubling of food production to keep pace with population growth. Within the continent there is a substantial number of human capacity professionals who are global leaders in food, nutrition and related professions. Some research organisations in the continent directly or indirectly benefit from grants administered by developed economies but a challenge exists with brain drain and ageing of qualified and experienced experts. Increasing educational need, coupled with the growing population necessitates attention to ensuring a sustained supply of highly trained, adequately equipped and qualified professionals in the relevant fields of food and nutrition sciences. Higher educational institutions exist in especially those that fall within the 500 in world universities ranking. Research activities take place in the continent along with the translation of research outputs into commercialisable products. Research towards transforming agriculture for improved livelihoods is taking place in different parts of the continent. Education, governance, gender and rural development are the key challenges. Income growth and the impacts of climate change on food production have contributed to food insecurity. ICTs can play an important role for FNS. Strengthening research, development, capacity building and industry cooperation are critical for FNS in Africa.