The coffee of Arabica Kintamani is one of the most popular coffees in the world due to its specific taste. The quality of coffee beans depends on the post-harvest and processing method. Dry processing and wet processing are the most popular methods used and each process produces different quality coffee beans. The objective of this research was to study and analyze various processing methods of coffee beans and to determine the best processing method to apply by the farmers and processors. This research consisted of three processing methods for the coffee namely dried processing (natural); wet processing; and semi-wet processing (honey). The research used a randomized complete design with one factor and five replications. The study showed that dry processing (natural) produced good quality coffee beans compared with wet or semi-wet processing, with significantly higher polyphenols content of 40.80 ± 0.053 mg GAE g−1 , approximately the same caffeine content (1.19 ± 0.016 %), significantly higher antioxidant activity (% DPPH) 89.53 ± 0.229 % with an EC50 equal to 102.44 ± 0.130 mg L−1 , similar lightness 13.63 ± 8.281 and a significantly lower moisture content of 7.54 ± 0.474 %. This indicated that dry processing could be used as an alternative processing method by farmers and processors due to it being easier, cheaper, with more efficient water use as well as giving a product contained the highest levels of polyphenols and antioxidant activity that are good for human health.

Maritime pine bark (Pinus pinaster Aiton subsp. atlantica) is rich in polyphenols with known bioactive properties which are beneficial for human health. However, biological activities of bark extracts depend on the type of polyphenols extracted and the characteristics of these extractives depend on several factors such as the type of solvents used. The influence of the extraction solvent on the composition and consequently on the properties of the extracts has been poorly described. Thus, in this study the influence of the extraction solvent (water, ethanol and ethanol-water (50/50 v/v%)) on the antibacterial and anticancer properties of P. pinaster bark samples were evaluated. LC-DAD-MS profiling of the different extracts was also carried out to study their polyphenol composition. Results show that extraction solvent must be carefully chosen with respect to foreseeing use of bark extracts, since ethanolic and hydroethanolic extracts displayed the greatest antibacterial activity whereas water extracts showed increased anticancer properties.

Creativity and innovation in culinary research have gained steady academic interest over the last decade. The scholastic interest in creative innovation ranges from its artistic value to culinary creations, gastronomic experiences, and food science and technology. Creative innovation is important for food enterprises to succeed in a highly competitive market. In the context of the New Nordic Cuisine, entrepreneurs and chefs are constantly challenged to bring something new to the dining table. In this context, the processes of creative innovation remain under researched, particularly in the use of seaweed. As such, using the example of seaweed, a relatively new food in the New Nordic Cuisine, the objective of this corpus based study was to explore creative innovation from a systems integral approach, in order to uncover salient themes that contribute the processes of creative innovation in culinary research, and bringing new foods to market. For a corpus driven study, we built a small corpora of interviews with chefs, and food entrepreneurs. We enquired after what inspired and motivated them when faced with a challenge of bringing a relatively new food to market, or in creating new dishes with new available food technologies. The results suggested that food technology plays a critical role in creative innovation, and the resulting new dishes that can be presented to customers. They also suggested that seaweed in the New Nordic Cuisine is an emerging food concept, and that it is embedded in a social and cultural history and familiarity of the Nordic people.

The partial lockdown during the Covid-19 pandemic in Indonesia pushed people to work from and spend more time at home. During this unprecedented time, many people pursued new hobbies in gardening, which proved to enhance physical and mental health. With anxieties regarding food insecurity, food gardens became a new urban trend. With a relatively tiny space available, it is possible to make an urban food garden in the front yard of a house using various cultivation techniques to maximize space. However, the implementation of food gardens in urban houses is quite challenging due to limited space. Then, we reflect on the practical process and personal benefits gained from developing a tiny food garden at home. The tiny food garden could produce a variety of vegetables and herbs, such as the spinach family, lettuce, Asian greens, the tomato family, eggplants, the basil family, mint, rosemary, moringas, and butterfly-pea flowers. It may support a household with few amounts of fresh emergency food in the worst scenario during the Covid-19 pandemic. Besides, developing a tiny food garden at home may also provide co-benefits such as enhanced subjective well-being, increased appreciation of food and the environment, motivating others to start gardening at home, and great personal satisfactions of consuming home-grown food. With all these socio-ecological co-benefits, home food garden must be integrated as a strategy to achieve urban sustainability and increase household food resilience.

This research aimed to study the effect of sterility values on physical quality (drained weight, brown colour index, and texture) and sensory properties of canned Agaricus bisporus mushrooms processed at different retort temperatures (115, 121, and 130 °C) and processing times (2-97 minutes). Mushrooms in brine solution media packaged in 300x407 cans were heated in industrial-scale horizontal static retorts at different retort temperatures for specific processing times to reach different F0-values. The canning process was carried out following commercial production procedures in one of the mushroom canning factories. Measurement of heat penetration into the product was carried out using a protocol established by the Institute of Thermal Process Specialists (IFTPS), and the sterility values (F0) were calculated. Our results indicated that the physical and sensory properties of canned mushrooms were not only affected by sterility value but also by the combination of temperature and time used to process the product. At the same level of sterility, a higher retort temperature (130 °C) resulted in canned mushroom with a lower browning rate, an improved texture profile (decreased hardness, increased chewiness, and shear force), a sweeter taste, and increased intensity of umami taste. However, the canning process at a temperature of 130 °C resulted in a greater reduction of the drained weight as compared to that of canning at 115 °C and 121 °C.

The research aimed to study the effect of drying processes (spray and freeze drying), and feed concentrations (80%, 65% and 50% of plant in water, w/w) on physicochemical and microbiological characteristics of star gooseberry (Sauropus androgynus), ceylon spinach (Basella alba), and cowslip creeper (Telosma minor ). After drying, the powder recovery of herbal plant powders was up to 77.47%. The aw and moisture content of spray-dried powder (SDP) were lower than that of freeze-dried powder (FDP). The drying method did not significantly affect nutritional values of both powders, whereas the feed concentrations markedly affected the nutritional values of the powders. The fibre and fat contents of powder prepared from 80% feed concentration had the highest values (p<0.05). The dried star gooseberry powder was rich in protein (13.01-16.81%) and fibre (5.03-5.52%). The colour of FDP represented a smaller change than that of SDP. The dried powders prepared by 80% showed the highest solubility, up to 85.44%. The microbial counts of SDP were lower than that of FDP. The colour might well have been preserved by freeze drying, whereas a low moisture and microbial count were likely due to the spray drying.

There are many opportunities in the global food market for innovations, through the valorization of artisanal technologies based on the local raw material. In this context we were interested in the development of cookies based on a local variety of sorghum from northern Cameroon, the so-called S35 sorghum variety and a local cowpea from northern Cameroon the so called "sekem variety". During the production of flours for cookies, the extraction yields were as follows: 46.67% for sorghum flour and 55.60% for cowpea flour. It was found that it was technically possible to produce these types of cookies. Several production trials were done and submitted to a panel for sensory analysis. The results showed that amongst different produced cookies, the one with 45% sorghum, 40% wheat, and 15% cowpea was the most appreciated by the members of the test panel. 70% of panelists considered them as "very good" against 30% who considered them as "good". 60% of test panelists indicate that cookies with 50% sorghum, 40% wheat and 10% cowpea were "good", against 40% who thought they were "not too bad". Meanwhile 50% of the test panelists considered that the cookies made of 55% sorghum, 40% wheat and 5% cowpea were "good" against 50% who indicate this as "bad" and "not too bad". Proximate analysis of the cookies of trial 3 showed that it contained about 12.50% proteins, 84.10% carbohydrates, 27.34% lipids and 1.50% fiber.

Packaging has an enabling role in supply chains (SCs) as it facilitates a range of functions, specifically (i) marketing; (ii) logistics and SC management; (iii) food technology; and (iv) environmental protection. This study explores the appreciation towards certain food packaging factors and attributes by consumers and industrial experts for a range of food product types. Primary data was collected through a questionnaire in the Greek market and then analysed using a 1-way ANOVA and the Tukey test. The study findings reveal that food SC stakeholders mainly appreciate packaging attractiveness. Other attributes that promote environmental sustainability and facilitate logistics operations were of high importance as well.

Three types of mills (Buhler, Quadrumat, and industry mill) have been used to determine the effect of mill type on the quality of the produced flour. Quadrumat and Buhler mills are usually used to produce flour at a laboratory level. Flour quality has been determined physically, chemically, and rheologically. Results showed that the particle size of flour produced by Buhler mill (FPB) was finer (mostly less than 132 μm) than other produced flour, while flour produced by Quadrumat mill (FPQ) had 8% particle size bigger than 50gg, which is more than Iraqi accepted limit (5%). The moisture content of FPQ exceeded the moisture content limit (14%). While, all flour produced by industry mills (FPI) was within the Iraqi standard in term of particle sizes and moisture content. Gluten content of FPB was higher than other produced flours; however, most increments were not significantly different. The results also showed that using different mills has no clear effect on the gluten index and alpha-amylase activity. Farinogram and extensogram results showed that FPQ was stronger than other produced flour followed by FPI. In conclusion, the quality of FPQ was closer to the quality of FPI, however, Quadrumat mill needs to be adjusted to produce flour with finer particle sizes and lower moisture content. The Buhler mill, on the other hand, needs to be adjusted to produce flour with bigger particle size. Both laboratory mills (Quadrumat and Buhler) need to be adjusted to produce flour that expresses FPI correctly.

Hot Smoked Spiced Catfish (HSSC) samples prepared under optimal conditions (garlic, 7.29 g/100 ml; ginger, 7.50 g/100 ml; turmeric, 2.5 g/100 ml; soaking temperature, 38.68 °C and soaking time, 7.51 min) were stored at ambient temperature (30±2 °C) for a period of 20 days to evaluate storage stability; un-spiced hot smoked catfish served as control. Moisture Content (MC), Thiobarbutric Acid (TBA), Peroxide Value (PV), Free Fatty Acid (FFA), Total Viable Counts (TVC) and Mould Counts (MoC) were monitored at two-day intervals as a measure of the storage stability indices. Sensory attributes of the Optimized Hot Smoked Spiced Catfish (OHSSC), control (unspiced) and commercial hot-smoked catfish were determined using a preference test. The storage stability indices values for HSSC were in the range of 6.64 - 7.01% (MC), 4.50 - 13.77 mg MDA/kg (TBA), 0.20 - 2.84 mEq/kg (PV), 0.72 - 9.64% (FFA), 9.50 - 57.00 cfu/g (TVC), 8.00 - 34.50 cfu/g (MoC). The control sample values were in the range of 6.97 - 7.30% (MC), 5.51 - 14.92 mg MDA/kg (TBA), 0.23 to 2.86 mEq/kg (PV), 2.24 - 11.88% (FFA), 13.50 - 113.00 cfu/g (TVC), and 10.00 - 49.00 cfu/g(MoC). The sensory evaluation indicated that OHSSC was most preferred in all the evaluated sensory parameters. This study established the synergistic effects of garlic and turmeric on the keeping quality and sensory attributes of hot-smoked catfish with the prospect of reducing post harvest losses.