γ-Glutamyltranspeptidase (GGT) hydrolyzes γ-glutamyl compounds and transfers their γ-glutamyl moieties to amino acids and peptides.  We previously showed that the “umami” taste of soy sauce could be improved by the addition of salt-tolerant Bacillus subtilis GGT to the fermentation mixture, “moromi”.  Although miso fermentation is a semi-solid fermentation, unlike soy sauce fermentation, this was also the case. When 15 units of purified B. subtilis GGT were added to 418 g miso “moromi” (fermentation mixture), the glutamate concentration in “moromi” became 20 mM higher and the “umami” taste became stronger than without the addition of GGT after 2 to 6 months of fermentation.  In addition, γ-Glu-Val and γ-Glu-Val-Gly, which are known as “kokumi” peptides, were identified in “tamari”, and the concentrations of these γ-glutamyl peptides in “tamari" fermented by the addition of GGT were significantly higher than those of “moromi” without the addition of GGT.  These results indicate that B. subtilis GGT is able to improve the taste of miso.

Antimicrobials like potassium sorbate, sodium propionate, and benzoic acid were incorporated in corn starch based formulation to investigate their effect on mechanical, water vapour barrier and optical properties of the developed self supporting edible film. The film was prepared by casting technique.When incorporated at 1.40% and above, potassium sorbate decreased the tensile strength (about 22%) and increased the elongation (about 55%) of control film; whereas, it increased the water vapour permeability by 15% only when added at 2.66%. At 2.66%, benzoic acid reduced the tensile strength by 24% and sodium propionate increased elongation by 17%. These two antimicrobials did not change the water vapour permeability. However, all the three antimicrobials adversely affected the optical properties by decreasing the whiteness index, increasing yellowness index, and reducing the surface gloss, with potassium sorbate showing the maximum effect. Among the three antimicrobials, sodium propionate appeared to be the best with minimum deterioration of film properties.

Solid lipid microparticles produced with a mixture of cupuacu butter and stearic acid were used to microencapsulate a commercial casein hydrolysate (Hyprol 8052). The composition of the lipid matrix used for the production of the lipid microparticles was chosen according to data on the wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC) of bulk lipid mixtures, which indicated that the presence of 10 % cupuacu butter was sufficient to significantly change the crystalline arrangement of pure stearic acid. Preliminary tests indicated that a minimum proportion of 4 % of surfactant (polysorbate 80) was necessary to produce empty spherical lipid particles with average diameters below 10 mm. The lipid microparticles were produced using 20 % cupuacu butter and 80 % stearic acid and then stabilized with 4 % of polysorbate 80, exhibiting an encapsulation efficiency of approximately 74 % of the casein hydrolysate. The melting temperature of the casein hydrolysate-loaded lipid microparticles was detected at 65.2 °C, demonstrating that the particles were solid at room temperature as expected and indicating that the incorporation of peptides had not affected their thermal behavior. After 25 days of storage, however, there was a release of approximately 30 % of the initial amount of encapsulated casein hydrolysate. This release was not thought to have been caused by the liberation of encapsulated casein hydrolysate. Instead, it was attributed to the possible desorption of the adsorbed peptides present on the surface of the lipid microparticles.

This work aimed to determine the mechanical properties of rough and dehulled rice grains, for different moisture contents, by obtaining their rupture force, deformation, maximum compression force and proportional deformity modulus under a compression test. Rice grains, with moisture content varying from 0.12 to 0.30 (d.b.), were subject to an uniaxial compression in order to analyze these properties. On reducting moisture content the rupture force increased from 37.2 to 70.6 N for dehulled rice and 48.0 to 79.5 N for rough rice. The average compression force varied from 131 to 171 N for dehulled rice and 203 to 283 N for rough rice. The value range of proportional deformity modulus was from 5.5 x 109 to 7.4 x 109 Pa for dehulled rice and 9.5 x 109 to 12.3 x 109 Pa for rough rice. Rough rice presented more resistance to compression compared to dehulled rice.

The quality of frozen foods can be negatively affected if improper storage and distribution temperatures are allowed. The objective of this study was to investigate the effect of freeze-thaw cycles, which may occur in the cold chain, on colour (Lab, Total Colour Differences (TCD), chroma and hue angle) and vitamin C (ascorbic and dehydroascorbic acids) content of frozen strawberries (Fragaria ×ananassa, Duschesne, cv. Selva). A plan of temperature abuses (TAs) was established, based on a real situation, and applied to frozen strawberries during a four month frozen storage period. The results showed that the lightness (L) was the only parameter that was not significantly affected by range of TAs studied. The colour showed some variation on the parameters a, b, TCD, chroma and hue angle. During TAs, ascorbic acid decreased about 75% and dehydroascorbic acid increased 73%. The non-abused strawberry samples showed better overall appearance than the abused samples.This work contributes to an understanding of the quality changes of frozen strawberries that might occur during frozen storage and cold chain distribution.

Education and training were an integral part of the MoniQA Network of Excellence. Embedded in the "Spreading of excellence programme", Work Package 9 (Joint education programmes and training tools) was responsible for establishing a joint training programme for food safety and quality within and beyond the network. So-called `MoniQA Food Scientist Training' (MoniQA FST) was offered to provide technical knowledge on different levels and research management skills as well. Training needs for different regions as well as for different target groups (scientists, industry personnel, authorities) had to be considered as well as developing strong collaboration links between network partners and related projects. Beside face-to-face workshops e-learning modules have been developed and web seminars were organized. In order to achieve high quality training, a quality assurance concept has been implemented. It turned out that these types of training are of high value in terms of bringing together scientists from different regions and cultures of the globe, involving highly qualified trainers as basis for a sustainable network in the future.

Moisture adsorption characteristics of California grown almonds (Nonpareil: pasteurized and unpasteurized almonds; Monterey: pasteurized, unpasteurized and blanched almonds) were obtained using the gravimetric method over a range of water activities from 0.11 to 0.98 at 7-50ºC. The weights of almonds were measured until samples reached a constant weight. The relationship between equilibrium moisture content and water activity was established using the Guggenheim-Anderson-de Boer model. The diffusion coefficient of water in almond kernels was calculated based on Ficks second law. The monolayer moisture value of almonds ranged from 0.020 to 0.035 kg H2O kg-1 solids. The diffusion coefficient increased with temperature at a constant water activity, and decreased with water activity at a constant temperature. The thermodynamic properties (net isosteric heat, differential enthalpy and entropy) were also determined. The net isosteric heat of adsorption decreased with the increasing moisture content, and the plot of differential enthalpy versus entropy satisfied the enthalpy-entropy compensation theory. The adsorption process of almond samples was enthalpy driven over the range of studied moisture contents.