The objectives of this study were to make yoghurt from camel milk and determine its physicochemical, microbiological and sensory qualities. The quality of camel milk yoghurt was compared with cow milk yoghurt and all parameters were analyzed following standard procedures. Yoghurt of acceptable consistency was made from camel milk using 1.2% gelatin, 5% bovine skim milk powder, 1.5 ml/L of calcium chloride, 40 ml/L of maple strawberry syrup and 6% yoghurt culture (YF-L811) and by incubating the milk at 42°C for 18 h. The average values for moisture, ash, syneresis, pH, titratable acidity and total solids of camel milk yoghurt were 83.4%, 1.13%, 58%, 4.37, 1.255% lactic acid and 16.7%, respectively. The corresponding values for cow milk yoghurt were 80.6%, 0.71%, 56%, 4.67, 0.865% lactic acid and 19.5%, respectively. The titratable acidity of camel milk yoghurt was significantly higher (P<0.05) than cow milk yoghurt; however, no significant difference was observed between the two yoghurt types for the other parameters. Coliforms were not detected in both yoghurt types. The sensory analysis showed that cow milk yoghurt was more preferred by the panellists than camel milk yoghurt. Production of yoghurt from camel milk using the same procedure as for cow milk yoghurt proved to be difficult.  Further research is called for to improve the acceptability of camel milk yoghurt using locally available and acceptable flavouring agents. Research needs to be conducted to optimize the operating parameters and standardize the production procedures of camel milk yoghurt in the future.

In humans, food oral processing (FOP) is the first step in the digestive process. It prepares the food for swallowing and to undergo the process of digestion. During chewing, the food is comminuted by the combined action of chewing and saliva to form a bolus. The particle size of the bolus is reduced due to the action of the tongue and the teeth, and the saliva is continuously produced by the salivary glands to humidify and impregnate the food. Saliva lubricates the bolus and enables the cohesion of particles to prepare for swallowing. During food oral processing, the compounds responsible for food flavour and taste are released, leading to the perception of food organoleptic properties and significantly contributing to the consumer’s acceptability of the product. Understanding this process of food breakdown and bolus formation thus appears to be a way to revisit food functional properties. However, this process is extremely complex, and as such, its description necessitates a combination of many quantities from different disciplines, i.e., physics, chemistry, physiology, psychology, behavioural science and food science. It depends, on one hand, on food properties and on the other hand, it depends on oral physiology. However, large inter-individual variability is commonly observed, which has important consequences on flavour release and perception. The challenge for the food industry is to be able to develop food considering this large variability, and sensory and nutritional constraints. This challenge is particularly relevant when specific populations (i.e., elderly, infants or obese subjects) are considered.

Dairy yogurts are common food products consumed by people all over the world. Due to the simple process, many people have made their own natural yogurt at home. The fermentation due to the starter culture causes the textural properties of dairy yogurt. However, the literature is surprisingly scarce on the topic of starter culture interactions in the development of textural properties of dairy yogurt. This study investigated the interaction effect of three common starter cultures, Lactobacillus acidophilus, Lactobacillus bulgaricus and Streptococcus thermophiles, on the viscosity of homemade yogurt. Using Design Expert software, a 10-run mixture model experiment was designed to examine the textural properties developed by single or multiple inoculation of these starter cultures. All yogurt formulations reached the isoelectric point of milk and had pHs in the range 3.97 to 4.32. Yogurt formulations with L. acidophilus and S. thermophilus resulted in viscosities which were similar to commercial yogurt viscosity (1.77 Pa·s), while L. bulgaricus resulted in yogurt with a lower viscosity. Based on the mixture model, L. acidophilus had most influence on the yogurt viscosity, followed by S. thermophilus and L. bulgaricus. In conclusion, L. acidophilus can be used as a single starter culture or combined with other starter cultures to develop high viscosity homemade yogurt. A Combination of S. thermophilus and L. acidphilus can also be used to develop high viscosity yogurts. However, L. bulgaricus should not be inoculated alone or become a dominant ratio in multiple starter culture inoculation as it will decrease the overall homemade yogurt viscosity.

Chopped green bell pepper pieces were blanched (95 °C, 5 min) and chemically pretreated (1% potassium metabisulphite solution, 25 min at room temperature) before drying in hot air dryer (HAD) at various temperature ranges (60 – 80 °C). Three vacuum levels (200, 400, 600 mm Hg) and microwave power levels (100, 200, 300 W) were also used to dry green bell pepper samples in a vacuum-assisted microwave (VAM) (2.45 GHz, 0.8 kW) dryer. VAM drying methods offered a maximum reduction by four to five times in drying time as compared to that in HAD. The logarithmic model was found to have the best fit based on high R2 and small values of reduced χ 2 and RMSE. VAM method has higher values for effective moisture diffusivity (Deff ) and lower values for activation energy (Ea), in comparison to the HAD method.

Quality reductions of raw and cooked vegetables are caused by forces generated during industrial high-speed manufacturing. However, the transferability of low-speed texture measurement methods to high speed processes is limited. Therefore, analyses with a low-speed uniaxial compression test (breaking strength σ, breaking strain ε) and a high-speed pendulum test (relative fracture height ∆h) at different speeds (3.6, 4.4, 5.3 m s−1 ) were carried out. Textural values for potatoes, carrots and celeriacs (0 to 25 min cooking time) were recorded to compare the two measurement methods. Furthermore, whether the increase of textural values of blanched vegetables measured with low-speed methods, was also observable with high-speed methods, was also investigated. Low to medium rank correlation coefficients (rS < 0.659) between parameters of the two methods were calculated. In contrast to σ and ε, ∆h-values indicate a distinct initial increase as well as textural maxima between 5.0 to 12.5 min cooking time for all tested potato and carrot varieties. On the other hand, most celeriac samples did not exhibit an increase in texture with respect to cooking time. Therefore, a textural analysis at high speeds is necessary for the prediction of textural characteristics of blanched vegetables during high-speed processing in order to reduce quality degradation.