Cutting tool parameters such as edge-sharpness and speed of cut directly influence the shape of final samples and the required cutting force and specific energy for slicing or cutting operations. Cutting force and specific energy studies on different vegetables help to design the appropriate slicing or cutting devices. Peak cutting force and specific energy requirements for the transverse cutting of nine vegetables, differing in their textural characteristics of rind and flesh, were determined at cutting speeds of 20, 30, 40 mm min−1 and single-cut knife-edge angles of 15, 20 and 25° using a Universal Testing Machine. Low speed (20 mm min−1 ) cutting with a sharper knife-edge angle (15°) required less peak force and specific energy than that of high-speed cutting (40 mm min−1 ) with a wider knife-edge angle (25°). The vegetables with the maximum and minimum variation in the average peak cutting force were aubergine, at 79.05 (for knife speed 20 mm min−1 and edge angle 15°) to 285.1 N (40 mm min−1 and 25°), and cucumber, at 11.61 (20 mm min−1 and 15°) to 21.41 N (40 mm min−1 and 25°), respectively. High speed (40 mm min−1 ), with a large knife-edge angle (25°), required the highest force and specific energy to cut the vegetables, however, low speed (20 mm min−1 ), with a small knife-edge angle (15°), is preferred. Effects of cutting speed and knife-edge angle on peak force and specific energy responses were found significant (p<0.05). Linear or quadratic regressions gave a good fit of these variables.

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.