Antimicrobials like potassium sorbate, sodium propionate, and benzoic acid were incorporated in corn starch based formulation to investigate their effect on mechanical, water vapour barrier and optical properties of the developed self supporting edible film. The film was prepared by casting technique.When incorporated at 1.40% and above, potassium sorbate decreased the tensile strength (about 22%) and increased the elongation (about 55%) of control film; whereas, it increased the water vapour permeability by 15% only when added at 2.66%. At 2.66%, benzoic acid reduced the tensile strength by 24% and sodium propionate increased elongation by 17%. These two antimicrobials did not change the water vapour permeability. However, all the three antimicrobials adversely affected the optical properties by decreasing the whiteness index, increasing yellowness index, and reducing the surface gloss, with potassium sorbate showing the maximum effect. Among the three antimicrobials, sodium propionate appeared to be the best with minimum deterioration of film properties.

Solid lipid microparticles produced with a mixture of cupuacu butter and stearic acid were used to microencapsulate a commercial casein hydrolysate (Hyprol 8052). The composition of the lipid matrix used for the production of the lipid microparticles was chosen according to data on the wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC) of bulk lipid mixtures, which indicated that the presence of 10 % cupuacu butter was sufficient to significantly change the crystalline arrangement of pure stearic acid. Preliminary tests indicated that a minimum proportion of 4 % of surfactant (polysorbate 80) was necessary to produce empty spherical lipid particles with average diameters below 10 mm. The lipid microparticles were produced using 20 % cupuacu butter and 80 % stearic acid and then stabilized with 4 % of polysorbate 80, exhibiting an encapsulation efficiency of approximately 74 % of the casein hydrolysate. The melting temperature of the casein hydrolysate-loaded lipid microparticles was detected at 65.2 °C, demonstrating that the particles were solid at room temperature as expected and indicating that the incorporation of peptides had not affected their thermal behavior. After 25 days of storage, however, there was a release of approximately 30 % of the initial amount of encapsulated casein hydrolysate. This release was not thought to have been caused by the liberation of encapsulated casein hydrolysate. Instead, it was attributed to the possible desorption of the adsorbed peptides present on the surface of the lipid microparticles.

Optimal conditions for the industrial extraction of total polyphenols from maté (Ilex paraguariensis) were determined using response surface methodology, with two independent variables: ethanol percentage of the extraction solution and liquid to solid ratio. Response variables were total polyphenol content, antioxidant capacity, concentration of total polyphenols and caffeine content.The optimal conditions found were a liquid to solid ratio from 8 - 9 w w-1 and ethanol percentage of the extraction solution from 30 -50 % w w-1. Under these conditions the main predicted values corresponding to leaf extracts were 40 μg chlorogenic acid equivalents mL-1 of original extract, 13 g chlorogenic acid equivalents per 100 g dry matter for total polyphenol content, 22 g Trolox equivalents and 15.5 g ascorbic acid equivalents per 100 g dry matter for antioxidant capacity. The total polyphenol content of twig extracts was 36% lower than that in the leaf extracts.

This work aimed to determine the mechanical properties of rough and dehulled rice grains, for different moisture contents, by obtaining their rupture force, deformation, maximum compression force and proportional deformity modulus under a compression test. Rice grains, with moisture content varying from 0.12 to 0.30 (d.b.), were subject to an uniaxial compression in order to analyze these properties. On reducting moisture content the rupture force increased from 37.2 to 70.6 N for dehulled rice and 48.0 to 79.5 N for rough rice. The average compression force varied from 131 to 171 N for dehulled rice and 203 to 283 N for rough rice. The value range of proportional deformity modulus was from 5.5 x 109 to 7.4 x 109 Pa for dehulled rice and 9.5 x 109 to 12.3 x 109 Pa for rough rice. Rough rice presented more resistance to compression compared to dehulled rice.

The objective of this research was to study the effects of modified atmosphere, associated with masterpack transport packaging, and refrigerated storage time on the quality characteristics of pork loin cuts. Cuts of pork loin were packaged in trays, covered with poly(vinyl chloride) film. The trays were placed in a masterpack (MP), containing three gas compositions:  A) 75% O2 : 25% CO2, B) 50% O2 : 50% CO2 or C) 100% CO2, and stored at 2 °C. Samples were taken after 1, 8, 15, and 22 days of storage, and evaluated for numerous shelf life traits. The development of Psychrotrophic aerobic bacteria and Pseudomonas spp. was found from the 15th day of storage. There was a significant treatment effect for some of the considered parameters, such as pH (P < 0.05) and color [L* (P < 0.07), a* (P < 0.07) and b* (P < 0.01)]. There was a significant interaction (P < 0.01) for the TBARS values. It can be concluded, from the microbiological point of view, that the use of modified atmospheres containing 25% to 100% CO2 promotes the conservation of meat for up to 15 days of storage under refrigeration. From the point of view of color, atmospheres containing 75% O2 : 25% CO2 and 50% O2 : 50% CO2 ensure the color of packaged pork meat when stored at 2 °C for up to 15 days. From the point of view of lipid oxidation, packages with 100% CO2 are recommended for storage periods of more than 15 days, whereas those with 75% O2 : 25% CO2 are recommended for storage periods of up to 8 days.

The objective of this study was to propose a multi-criteria optimization and decision-making technique to solve food engineering problems. This technique was demonstrated using experimental data obtained on osmotic dehydration of carrot cubes in a sodium chloride solution. The Aggregating Functions Approach, the Adaptive Random Search Algorithm, and the Penalty Functions Approach were used in this study to compute the initial set of non-dominated or Pareto-optimal solutions. Multiple non-linear regression analysis was performed on a set of experimental data in order to obtain particular multi-objective functions (responses), namely water loss, solute gain, rehydration ratio, three different colour criteria of rehydrated product, and sensory evaluation (organoleptic quality). Two multi-criteria decision-making approaches, the Analytic Hierarchy Process (AHP) and the Tabular Method (TM), were used simultaneously to choose the best alternative among the set of non-dominated solutions. The multi-criteria optimization and decision-making technique proposed in this study can facilitate the assessment of criteria weights, giving rise to a fairer, more consistent, and adequate final compromised solution or food process. This technique can be useful to food scientists in research and education, as well as to engineers involved in the improvement of a variety of food engineering processes.

Education and training were an integral part of the MoniQA Network of Excellence. Embedded in the "Spreading of excellence programme", Work Package 9 (Joint education programmes and training tools) was responsible for establishing a joint training programme for food safety and quality within and beyond the network. So-called `MoniQA Food Scientist Training' (MoniQA FST) was offered to provide technical knowledge on different levels and research management skills as well. Training needs for different regions as well as for different target groups (scientists, industry personnel, authorities) had to be considered as well as developing strong collaboration links between network partners and related projects. Beside face-to-face workshops e-learning modules have been developed and web seminars were organized. In order to achieve high quality training, a quality assurance concept has been implemented. It turned out that these types of training are of high value in terms of bringing together scientists from different regions and cultures of the globe, involving highly qualified trainers as basis for a sustainable network in the future.

A response study and the effects of different parameters (pH, temperature and enzyme dose) on kinetics of isolated soy protein hydrolysis by a trypsin-like endopeptidase (TL1) were conducted. Degree of hydrolysis (%DH) data varied at different times under different hydrolysis conditions. Fitting the kinetics data to Michaelis-Menten kinetics model did not result in reasonable kinetic parameters, which implied that Michaelis-Menten kinetics was invalid for such a hydrolysis process. A kinetics model proposed by (Gonzalez-Tello, Camacho, Jurado, Paez, & Guadix, 1994) was found to fit the kinetics curve well and resulted in acceptable model parameters. A simple simulation example was performed to demonstrate the concept of how the kinetics equation could be applied in process engineering.