The purpose of this study was to determine the most powerful aroma-active compounds of olive oils obtained from Ayvalik (AYV), Gemlik (GEM) and Memecik (MEM) cultivars harvested in 2011, using gas chromatography-mass spectrometry-olfactometry (GC-MS-O). Simultaneous distillation and extraction (SDE) with dichloromethane was used for extraction of volatile components. The aromaactive compounds of olive oils were evaluated by aroma extract dilution analysis (AEDA). A total of 14, 12 and 12 aroma-active compounds within the range of ≥64–1024 flavor dilution (FD) factors were detected in aromatic extracts of olive oils obtained from AYV, GEM and MEM cvs., respectively. The compounds having the highest FD factor (1024) were (Z)-3-hexenol (cut grass, herbal) and βsesquiphellandrene (floral) for AYV oil and (Z)-3-hexenyl acetate (fruity) for MEM oil. Among these compounds, terpenes were the overwhelmingly largest aroma-active components followed by aldehydes. 

The paper gives a brief overview of the current nutritional status of the Ukrainian population and describes useful buckwheat properties. The objective of the paper is to study the effect of buckwheat processing products (flour and flakes) on the technological process and quality of bread made from whole-wheat flour. This paper describes and analyzes research data on the rheological properties of dough samples which were determined by farinograph and amylograph. Investigation of structural and mechanical properties of dough showed an increase in water-absorbing capacity in all samples when adding buckwheat products. Moreover, dough made with buckwheat flakes has a lower value of mixing tolerance index (by 47 %) than dough made from buckwheat flour, and a higher valorimetric value (by 20 %). Determination of dough properties by amylogram has shown that a sample containing buckwheat flakes has a higher maximum viscosity than a sample containing buckwheat flour. Determination of the gas-production and gas-retention capacity of dough is also presented, along with an analysis of the quality of finished products based on the results of laboratory baking tests. The samples of bread supplemented with buckwheat flakes have better shape stability (by 21 %), specific volume (by 12 %) and porosity (by 11 %) than bread made from buckwheat flour. The organoleptic evaluation of finished product quality has shown that bread supplemented with buckwheat flakes has a more fluffy-texture, elastic crumb and uniform porosity than bread made from buckwheat flour. Buckwheat flakes proved to have a better effect on parameters of the technological process and quality of bread when compared with buckwheat flour.

In this experiment the effect on post-harvest preservation of papaya (Carica papaya L.) fruit coated with either Aloe gel (AG; 100%) or papaya leaf extract with Aloe gel (PLEAG; 1:1) was studied. To evaluate the role of coating on ripening behavior and quality of papaya the uncoated and coated fruits were stored and ripened at room temperature (25 °C-29 °C) and 82-84% relative humidity. Physico-chemical properties were analyzed at 4 day intervals during the storage period. The incidence of disease attack was also visually observed. The overall results showed the superiority of AG and PLEAG coating in lengthening the shelf-life of papaya fruit compared to controls which showed significant decay from 6th day onward and complete decay within 12 days of storage. The AG and PLEAG coated fruits maintained their shelf life for 12 days and decayed at 16th day. The coated fruits also maintained their color, flavor and firmness up to 12 days of storage. An increase in ascorbic acid content (120.2 mg/100 g) was also found in coated fruits in contrast to the control (59 mg/100 g). Only 27% disease incidence was observed in AG and 13% in PLEAG coated fruits as compared to control (100%) during the storage period. The results of this study show that both AG and PLEAG coatings have excellent potential to be used on fresh produce to maintain quality and extend shelf-life.

The main objective of this research was to compare the retention of antioxidant activity and total anthocyanin content of Saskatoon berries dried by freeze drying, microwave-vacuum drying, thin layer hot air drying and vacuum drying. Antioxidant activity of berry samples was determined by DPPH radical scavenging and ABTS radical scavenging, and the pH differential method was used to determine total anthocyanin content of the berry samples. The results showed that the freeze dried Saskatoon berries exhibited the highest retention of anthocyanin and antioxidant activity among the dried samples, followed by microwave-vacuum dried berries, thin layer hot air dried berries and vacuum dried berries. There were significant differences between the berry samples at P<0.05.  DPPH radical scavenging and ABTS radical scavenging were correlated linearly with an R2 value of 0.99 at P<0.05 showing their effectiveness for the determination of the antioxidant activity of the Saskatoon berries. However, the DPPH radical scavenging assay was more effective than the ABTS radical scavenging assay. The results also showed that antioxidant activity of the berries was highly correlated with the total anthocyanin content of the fruit. The reduction of anthocyanin in dried berry samples was linearly correlated with the reduction of DPPH radical scavenging with an R2 value of 0.97 at P<0.05 and, also, linearly correlated with the reduction of ABTS radical scavenging with an R2 value of 0.88 at P<0.05.

The quality of frozen foods can be negatively affected if improper storage and distribution temperatures are allowed. The objective of this study was to investigate the effect of freeze-thaw cycles, which may occur in the cold chain, on colour (Lab, Total Colour Differences (TCD), chroma and hue angle) and vitamin C (ascorbic and dehydroascorbic acids) content of frozen strawberries (Fragaria ×ananassa, Duschesne, cv. Selva). A plan of temperature abuses (TAs) was established, based on a real situation, and applied to frozen strawberries during a four month frozen storage period. The results showed that the lightness (L) was the only parameter that was not significantly affected by range of TAs studied. The colour showed some variation on the parameters a, b, TCD, chroma and hue angle. During TAs, ascorbic acid decreased about 75% and dehydroascorbic acid increased 73%. The non-abused strawberry samples showed better overall appearance than the abused samples. This work contributes to an understanding of the quality changes of frozen strawberries that might occur during frozen storage and cold chain distribution.

Oxidation decreases consumer acceptability of food by changing its organoleptic properties, destroying essential nutrients and producing toxic compounds. Antioxidants delay oxidation of lipids in foods as well in human systems. Studies reveal that synthetic antioxidants may trigger diseases in human when consumed over a certain concentration. The toxicological effects of synthetic food antioxidants have been the focus of controversy in recent years. There is scope to use natural antioxidants, present in many components of food and plant sources, as a preservative. In this review different synthetic and natural antioxidants present in various foods, reactions with food and the biological system, extraction techniques and their pitfalls as well as legal implication are discussed.

The aim of this work was to study the rheological, thermal and some other physical-chemical properties of selected honeys produced in the Northeast of Brazil. Two samples were produced by native “Jandaira” bees (Melipona subnitida) and ten other samples by Africanized bees (Apis mellifera). The samples were analyzed for pH, water activity (aW), soluble solids and water content. Viscosity flow curves were obtained using a rheometer (25ºC, 0-100s-1). Thermal analyses were performed on a differential scanning calorimeter, with heating rate of 10ºC/min (-100 to 100ºC). The water content and the pH of the honey samples varied from 17.2 to 27.9% and from 3.2 to 4.2, respectively, and, the aW of the samples varied from 0.57 to 0.74. Two samples were out of specification with respect to water content, according to Brazilian laws. In relation to rheology, all honey samples showed Newtonian behaviour with no thixotropy or dilatancy. The viscosity varied as an exponential function of the water content. The highest viscosity was obtained for the sample with lower values of water content and aW. Thermograms showed a glass transition (Tg) occurring between -52.4 and -42.6ºC, in the samples produced by Apis mellifera and -67.6 and -57.0ºC for the other samples. A linear relationship was obtained between Tg and water content. In conclusion, the honey viscosity depended on the water content of the product. The higher the water value and therefore the greater the aw, the lower viscosity and Tg of the samples.

The safety of camel milk was assessed along the value chain in Erer, eastern Ethiopia. A total of 24 camel milk samples were aseptically collected from producers in Erer (n=12), and wholesalers and retailers (n=12) along the chain. Milk quality parameters were analyzed following standard procedures. The mean (±SD) total bacteria (TBC), Enterobacteriaceae (EC), coliform (CC), spore-forming bacteria (SFBC) and yeast and mould (YMC) counts of the milk samples analyzed were 5.2 ± 1.90, 3.2 ± 2.30, 2.9 ± 2.27, 2.1 ± 2.41 and 2.7 ± 1.61 log10 cfu mL-1, respectively. The TBC, EC, CC and SFBC of milk samples obtained from retailers in the final marketing sites were significantly higher (P < 0.05) than those obtained from producers and wholesalers in Erer. Salmonella spp. was detected in milk samples collected from all sites. Other microorganisms isolated from camel milk samples include Staphylococcus aureus (16.2%), Entrobacter spp. (14.9%), Streptococcus spp. (13.5%),Escherichia coli (8.1%), Acinetobacter spp. (7.4%), Staphylococcus epidermidis (6.8%), Klebsiella spp. (6.1%), Bacillus spp. (5.4%), Corynebacterium spp. (5.4%), Micrococcus spp. (4.7%), Lactobacillus spp. (4.1%), Listeria spp. (4.1%), Pseudomonas spp. (2%) and Shigella spp. (1.4% ). The quality of camel milk produced in the study area was generally poor and microbial contamination of camel milk occurs along the value chain while it is transported from the production site to the market. This calls for strict hygienic measures along the entire value chain in order to improve the quality and safety of camel milk produced in the area evaluated.

Macro and micro-structural changes take place during food dehydration. Macro-structural changes encompass modifications in shape, area and volume. Studies of such changes are important because dehydration kinetics (essential for calculating industrial dryers) may be highly influenced by changes in food shape and dimensions. The overall changes in volume, surface area (“shrinkage”) and shape (Heywood factor, with provides a close description of food shape) were determined experimentally, and the results were correlated with simple expressions. Hence, although dehydration kinetics can be modeled with simplified overall shrinkage expressions, the possibility of selecting a suitable geometry and predicting the characteristics dimensions will provide higher accuracy. An additional unresolved problem is the lack of a general model that predicts macro-structural changes for various foods and diverse geometries. In this work, based on experimental data of sweet and sour cherries, and rose hip fruits, a simplified general model to predict changes in volume and surface area are proposed. To estimate how the changes in characteristic dimensions affect the kinetic studies, experimental drying curves for the three fruits by means of a diffusional model considered the following variants for the characteristic dimensions: (i) The radius of the fresh food, assumed constant; (ii) The radius of the partially dehydrated product; (iii) The radius predicted by the correlation for structural changes, especially volume, obtained in this work and generalized for the three fruits, and (iv) to demonstrate the need to study the macro-structural changes for all dehydrated foods, also be present the case of a restructured food.

The food & drink (F&D) sector in Europe ranks low in innovation and the European F&D industry has been losing importance in the global market. The food professionals, i.e., food scientists and technologists (FSTs), may not be meeting the varied demands of the sector. Here, we identify education, experience and skills of current FSTs and compare  geographic regions and employment areas. Between 2009 and 2012, 287 questionnaires representing over 4000 FSTs were collected from employers in 16 countries. Analyses showed that more than 80% of FSTs have a university degree; but only in Industry in the Central European region are most degrees in food science/technology. More than half of FSTs, and almost 60% in the South, have less than 10 years’ experience. The most common FST job title is Quality Manager, but with several variations based on region and employment area. Among skills, the most common is Communicating; found in over 90% of FSTs in all regions and employment areas. Food Safety is the most common of the food sector-specific skills, present in more than 75% of FSTs, yet there are differences in food sector skills based on employment area. Overall, these data suggest similarities among currently employed food professionals throughout Europe; they are young and highly educated, but also differences, especially in their food sector-specific skills. An understanding of the current FST should contribute to the improvement of FST training and thus benefit the European food sector.