The paper gives a brief overview of the current nutritional status of the Ukrainian population and describes useful buckwheat properties. The objective of the paper is to study the effect of buckwheat processing products (flour and flakes) on the technological process and quality of bread made from whole-wheat flour. This paper describes and analyzes research data on the rheological properties of dough samples which were determined by farinograph and amylograph.Investigation of structural and mechanical properties of dough showed an increase in water-absorbing capacity in all samples when adding buckwheat products. Moreover, dough made with buckwheat flakes has a lower value of mixing tolerance index (by 47 %) than dough made from buckwheat flour, and a higher valorimetric value (by 20 %). Determination of dough properties by amylogram has shown that a sample containing buckwheat flakes has a higher maximum viscosity than a sample containing buckwheat flour. Determination of the gas-production and gas-retention capacity of dough is also presented, along with an analysis of the quality of finished products based on the results of laboratory baking tests.The samples of bread supplemented with buckwheat flakes have better shape stability (by 21 %), specific volume (by 12 %) and porosity (by 11 %) than bread made from buckwheat flour. The organoleptic evaluation of finished product quality has shown that bread supplemented with buckwheat flakes has a more fluffy-texture, elastic crumb and uniform porosity than bread made from buckwheat flour. Buckwheat flakes proved to have a better effect on parameters of the technological process and quality of bread when compared with buckwheat flour.

γ-Glutamyltranspeptidase (GGT) hydrolyzes γ-glutamyl compounds and transfers their γ-glutamyl moieties to amino acids and peptides.  We previously showed that the “umami” taste of soy sauce could be improved by the addition of salt-tolerant Bacillus subtilis GGT to the fermentation mixture, “moromi”.  Although miso fermentation is a semi-solid fermentation, unlike soy sauce fermentation, this was also the case. When 15 units of purified B. subtilis GGT were added to 418 g miso “moromi” (fermentation mixture), the glutamate concentration in “moromi” became 20 mM higher and the “umami” taste became stronger than without the addition of GGT after 2 to 6 months of fermentation.  In addition, γ-Glu-Val and γ-Glu-Val-Gly, which are known as “kokumi” peptides, were identified in “tamari”, and the concentrations of these γ-glutamyl peptides in “tamari" fermented by the addition of GGT were significantly higher than those of “moromi” without the addition of GGT.  These results indicate that B. subtilis GGT is able to improve the taste of miso.

There is growing interest in the use of natural agents with antimicrobial (AM) and antioxidant (AOX) properties. Optimization of the AM capacity for mixtures containing carvacrol, grape seed extract (GSE) and chitosan, against gram-negative (Pseudomonas aeruginosa), gram-positive bacteria (Staphylococcus aureus, Listeria innocua and Enterococcus faecalis) and yeast (Saccharomyces cerevisiae) at 106 cfu mL-1 was studied. To observe the synergistic or antagonistic effect and find optimal combinations between the three agents, a simplex centroid mixture design was run for each microorganism, combining carvacrol (0-300 ppm, X1), GSE (0-2000 ppm, X2) and chitosan (0-2% w/v, X3). Results of the response surface analysis showed several synergistic effects for all microorganisms. Combinations of 60 ppm-400 ppm-1.2% w/v (carvacrol-GSE-chitosan; optimal AM combination 1, OAMC-1); 9.6 ppm-684 ppm-1.25% w/v (OAMC-2); 90 ppm-160 ppm-1.24% w/v (OAMC-3) were found to be the optimal mixtures for all microorganisms. Radical scavenging activity (RSA) of the same agents was then compared with a standard AOX (butylated hydroxytoluene; BHT) at different concentrations (25, 50 and 100 ppm; as well as the optimal AM concentrations) by the 1,1-diphenyl-2-picrylhydrazyl (DPPH) method. RSA increased in the following order: chitosan< carvacrol< BHT< GSE and for the OAMC: OAMC-2< OAMC-1< OAMC-3. The best RSA (OAMC-3) was applied as a coating in two different food matrices (strawberries and salmon). For strawberries, P. aeruginosa was more sensitive to the action of OAMC-3 than S. cerevisiae. For salmon, S. aureus was more resistant to the action of OAMC-3 than E. faecalis and L. innocua.

Oxidation decreases consumer acceptability of food by changing its organoleptic properties, destroying essential nutrients and producing toxic compounds. Antioxidants delay oxidation of lipids in foods as well in human systems. Studies reveal that synthetic antioxidants may trigger diseases in human when consumed over a certain concentration. The toxicological effects of synthetic food antioxidants have been the focus of controversy in recent years. There is scope to use natural antioxidants, present in many components of food and plant sources, as a preservative. In this review different synthetic and natural antioxidants present in various foods, reactions with food and the biological system, extraction techniques and their pitfalls as well as legal implication are discussed.

Honey quality is clearly defined in the EU Directive 2001/110/EC, and by Codex Alimentarius (Codex Stan 12-1981) and the International Honey Commission (IHC, 2002). Our investigation aimed to characterize the physicochemical properties of honey produced on a small island, Gozo which is situated near Malta.  Ten randomly collected honey samples were analysed for moisture content, pH, free acidity, water insoluble content, hydroxymethylfurfural (HMF) content and total phenolic compounds.  Moisture content, pH, free acidity, water insoluble content, and HMF content were within the range specified in standards but the electrical conductivity was generally higher than 0.800 mS cm-1. This may be the result of the relatively high atmospheric and soil salinity on this small island. All the samples analysed were within the 40 mg kg-1 HMF limit, which is an indicator of honey quality. The total phenolic compounds, which represent some of the constituents derived from the nectar and pollen obtained during foraging, ranged between 236.555 and 294.209 GAE kg-1 honey. Principal Component Analysis showed the properties of polyfloral honey samples obtained from the southern part of the island to be different from those obtained from the northern part.