Beef-in-sauce catering meals under blast-cooling have been investigated in a research project which aims at quantitative HACCP (hazard analysis critical control point). In view of its prospective coupling to a predictive microbiology model proposed in the project, zero-order spatial dependence has proved to suitably predict meal temperatures in response to temperature variations in the cooling air. This approach has modelled heat transfer rates via the a priori unknown convective coefficient hc which is allowed to vary due to uncertainty and variability in the actual modus operandi of the chosen case study hospital kitchen. Implemented in MS Excel®, the numerical procedure has successfully combined the 4
th order Runge-Kutta method, to solve the governing equation, with non-linear optimization, via the built-in Solver, to determine the coefficient hc. In this work, the coefficient hc was assessed for 119 distinct recently-cooked meal samples whose temperature-time profiles were recorded in situ after 17 technical visits to the hospital kitchen over a year. The average value and standard deviation results were hc = 12.0 ± 4.1 W m−2 K −1 , whilst the lowest values (associated with the worst cooling scenarios) were about hc ≈ 6.0 W m−2 K −1 .Convective heat transfer

In European Higher Education, learning outcomes and competences have been used sometimes with different meanings and sometimes with the same meaning. But both terms have been more commonly used to refer to knowledge, understanding and abilities a student must demonstrate at the end of a learning experience. Their use is a consequence of the paradigm shift of the Bologna Process to a learner centered education environment. The definition of standards of competences (or learning outcomes) for the PhD degree is thus a need for the quality assurance of this degree. In this work, subject-specific and generic competences for the PhD in Food Science and Technology and their alignment with the European Qualifications Framework (EQF) level descriptors for quality assurance purposes have been identified.

Microwave popping characteristics of a particular variety of paddy were studied using a domestic microwave oven. The experiments were carried out at 4 levels of moisture content (around 13%, 14%, 15% and 16% wb), 3 levels of power (600 W, 850 W and 1000 W) and 5 levels of heating time (40 s, 60 s, 80 s, 100 s and 120 s). A general factorial experiment design was followed, and effect of different treatment combinations on popping percentage and expansion ratio of the paddy was evaluated. The maximum popping percentage of 63.47% was obtained at a moisture content of 14.15% and energy level of 80 kJ (1000 W and 80 s) while the maximum expansion ratio of 4.42 was obtained at 14.94% moisture content and energy level of 68 kJ (850 W and 80 s). Optimum values of microwave power, time of heating and moisture content of paddy were achieved at 1000 W, 80 s and 15%, respectively, corresponding to popping percentage and expansion ratio of 58.73 and 3.58.

Yerba mate infusion is widely consumed in Argentina, Brazil and Paraguay. One of the processing steps used in Argentina is aging. The following three methods were used to age yerba mate: 1) air humidity and temperature-controlled aging; 2) temperature-controlled aging and 3) no control. The aim of this research was to determine the physicochemical and sensory attribute differences when yerba mate was aged using these three methods. The concentration of caffeine, glucose, fructose, maltose and phenolic compounds and pH diminished in all three aging methods but by different percentages. The sensory attributes did not exhibit uniform behaviour. Astringency remained constant in the first method and diminished in the other two. Bitterness increased in all three methods but by different percentages. Sweetness diminished in all three methods. Notably few correlations were determined between physicochemical and sensory attributes.

The characteristics of the thermal gelation of squid mantle paste and the effect of protease inhibitors on them were investigated. Pastes in the absence and presence the protease inhibitors, ethylendiaminetetracetic acid (EDTA) and phenylmethylsulfonyl fluoride (PMSF), were formulated. Pastes were made by the respective one or two step thermal treatments: direct heating at 85°C for 20 min and preincubation at 27 or 40 °C for 3 or 2 hours, followed by heating at 85 °C for 20 min. The gel strength, water holding capacity (WHC) and whiteness of gelled pastes were analyzed. The tricloroacetic acid (TCA) soluble peptides in homogenate of the muscle were determined. Gel strength decreased when heating was made in two steps. EDTA and PMSF were effective in avoiding that decrease when pre-incubation was made at 40 °C. Maximum gel strength was observed for the gels in presence of EDTA, giving values of 255 and 219 g x cm for the samples made by direct heating and pre-incubated at 40 °C  respectively. TCA soluble peptides increased between 20 and 60 °C, with maximum values reached at 30 and 60 °C. No significant differences (p>0.05) were observed in gel whiteness, neither with the thermal treatment nor with the inhibitors. The WHC was higher (p<0.05) in the gelated paste formulated with EDTA. These results show a good gelation capacity of I argentinus pastes and improvements with protease inhibitors. 

Protein isolate 1 (PI1) and protein isolate 2 (PI2) were prepared from industrially produced sunflower meal by using isoelectric and ethanol precipitation respectively. The water absorption capacity of PI1 was 6 times higher than that of PI2 and was significantly reduced by the presence of 0.03 M and 0.25 M NaCl. Oil absorption capacity of both protein isolates was not influenced by NaCl supplementation. Foam capacity of PI1 and PI2 was pH-dependent. While the foam capacity of both isolates was improved by either 0.03 M or 0.25 M NaCl, the foam stability was negatively influenced by the addition of NaCl at all pH values with except for pH 4. Emulsifying activity of PI1 and PI2 was lowest at pH 4. The emulsions exhibited relatively high stability (> 90%) under all studied conditions. Knowledge of the influence of pH and boundary concentrations of NaCl on the functionality of sunflower meal protein isolates could be beneficial for their future potential application in food industry. 

This study aimed to establish the effects of lactic fermentation on the levels of β-carotene in selected  orange fleshed sweet potato (OFSP) varieties from Kenya.  Furthermore,it sought to demonstrate fermentation as a potential process for making new products from sweet potato with enhanced nutraceutical attributes. The varieties (Zapallo, Nyathiodiewo and SPK004/06) were fermented with Lactobacillus plantarum MTCC 1407 at 25 ± 2°C for 48 h and kept for 28 days to make lacto-pickles. During fermentation both analytical [pH, titratable acidity (TA), lactic acid (LA), starch, total sugar, reducing sugar (g/kg roots), texture (N/m2), β-carotene (mg/kg roots)] and sensory (texture, taste, flavour and after taste) attributes of sweet potato lacto-juice were evaluated. Process conditions were optimized by varying brine levels, with fermentation time. A UV-visible spectrophotometer was used to identify and quantify β-carotene. Any significant variations (p < 0.05) in analytical attributes between the fermented and unfermented samples (pH, LA, TA and β-carotene concentration) of lacto-pickles, prepared from the potato roots, were assessed. The study reported a final composition of 156.49mg/kg, 0.53mg/kg, 0.3N/m2, 1.3g/kg, 5.86g/kg, 0.5g/kg and 5.86g/kg for β-carotene, Ascorbic acid, texture; Starch, total sugars, LA and TA respectively, and a pH of 3.27. The fermented products were subjected to flavour profiling by a panel. The product sensory scores were 1.5 to 2.5 on a 5 point hedonic scale, ranging from dislike slightly to like much. The products with brine levels at 4 and 6% were most preferred. The retention of β-carotene was 93.97%. This demonstrated lactic acid fermentation as a better method for processing OFSP as the main nutritional attributes are retained. The final product was resistant to spoilage microorganisms after 28 days of fermentation. Further preservation could be obtained by addition of sodium metabisulphite. In conclusion, Lactic acid fermentation using L. plantarum is a novel method of producing Lacto pickles from Zapallo OFSP, with 93.97% β-carotene retention and adequate shelf life.