Beef-in-sauce catering meals under blast-cooling have been investigated in a research project which aims at quantitative HACCP (hazard analysis critical control point). In view of its prospective coupling to a predictive microbiology model proposed in the project, zero-order spatial dependence has proved to suitably predict meal temperatures in response to temperature variations in the cooling air. This approach has modelled heat transfer rates via the a priori unknown convective coefficient hc which is allowed to vary due to uncertainty and variability in the actual modus operandi of the chosen case study hospital kitchen. Implemented in MS Excel®, the numerical procedure has successfully combined the 4
th order Runge-Kutta method, to solve the governing equation, with non-linear optimization, via the built-in Solver, to determine the coefficient hc. In this work, the coefficient hc was assessed for 119 distinct recently-cooked meal samples whose temperature-time profiles were recorded in situ after 17 technical visits to the hospital kitchen over a year. The average value and standard deviation results were hc = 12.0 ± 4.1 W m−2 K −1 , whilst the lowest values (associated with the worst cooling scenarios) were about hc ≈ 6.0 W m−2 K −1 .Convective heat transfer

The paper gives a brief overview of the current nutritional status of the Ukrainian population and describes useful buckwheat properties. The objective of the paper is to study the effect of buckwheat processing products (flour and flakes) on the technological process and quality of bread made from whole-wheat flour. This paper describes and analyzes research data on the rheological properties of dough samples which were determined by farinograph and amylograph.Investigation of structural and mechanical properties of dough showed an increase in water-absorbing capacity in all samples when adding buckwheat products. Moreover, dough made with buckwheat flakes has a lower value of mixing tolerance index (by 47 %) than dough made from buckwheat flour, and a higher valorimetric value (by 20 %). Determination of dough properties by amylogram has shown that a sample containing buckwheat flakes has a higher maximum viscosity than a sample containing buckwheat flour. Determination of the gas-production and gas-retention capacity of dough is also presented, along with an analysis of the quality of finished products based on the results of laboratory baking tests.The samples of bread supplemented with buckwheat flakes have better shape stability (by 21 %), specific volume (by 12 %) and porosity (by 11 %) than bread made from buckwheat flour. The organoleptic evaluation of finished product quality has shown that bread supplemented with buckwheat flakes has a more fluffy-texture, elastic crumb and uniform porosity than bread made from buckwheat flour. Buckwheat flakes proved to have a better effect on parameters of the technological process and quality of bread when compared with buckwheat flour.

The so-called vegetable milks are in the spotlight thanks to their lactose-free, animal protein-free and cholesterol-free features which fit well with the current demand for healthy food products. Nevertheless, and with the exception of soya, little information is available about these types of milks and their derivatives. The aims of this review, therefore, are to: highlight the main nutritional benefits of the nut and cereal vegetable milks available on the market, fermented or not; describe the basic processing steps involved in their manufacturing process; and analyze the major problems affecting their overall quality, together with the current feasible solutions. On the basis of the information gathered, vegetable milks and their derivatives have excellent nutritional properties which provide them a high potential and positive market expectation. Nevertheless, optimal processing conditions for each raw material or the application of new technologies have to be researched in order to improve the quality of the products. Hence, further studies need to be developed to ensure the physical stability of the products throughout their whole shelf-life. These studies would also allow for a reduction in the amount of additives (hydrocolloids and/or emulsifiers) and thus reduce the cost of the products. In the particular case of fermented products, the use of starters which are able to both improve the quality (by synthesizing enhanced flavors and providing optimal textures) and exert health benefits for consumers (i.e. probiotics) is the main challenge to be faced in future studies.

This study aimed to establish the effects of lactic fermentation on the levels of β-carotene in selected  orange fleshed sweet potato (OFSP) varieties from Kenya.  Furthermore,it sought to demonstrate fermentation as a potential process for making new products from sweet potato with enhanced nutraceutical attributes. The varieties (Zapallo, Nyathiodiewo and SPK004/06) were fermented with Lactobacillus plantarum MTCC 1407 at 25 ± 2°C for 48 h and kept for 28 days to make lacto-pickles. During fermentation both analytical [pH, titratable acidity (TA), lactic acid (LA), starch, total sugar, reducing sugar (g/kg roots), texture (N/m2), β-carotene (mg/kg roots)] and sensory (texture, taste, flavour and after taste) attributes of sweet potato lacto-juice were evaluated. Process conditions were optimized by varying brine levels, with fermentation time. A UV-visible spectrophotometer was used to identify and quantify β-carotene. Any significant variations (p < 0.05) in analytical attributes between the fermented and unfermented samples (pH, LA, TA and β-carotene concentration) of lacto-pickles, prepared from the potato roots, were assessed. The study reported a final composition of 156.49mg/kg, 0.53mg/kg, 0.3N/m2, 1.3g/kg, 5.86g/kg, 0.5g/kg and 5.86g/kg for β-carotene, Ascorbic acid, texture; Starch, total sugars, LA and TA respectively, and a pH of 3.27. The fermented products were subjected to flavour profiling by a panel. The product sensory scores were 1.5 to 2.5 on a 5 point hedonic scale, ranging from dislike slightly to like much. The products with brine levels at 4 and 6% were most preferred. The retention of β-carotene was 93.97%. This demonstrated lactic acid fermentation as a better method for processing OFSP as the main nutritional attributes are retained. The final product was resistant to spoilage microorganisms after 28 days of fermentation. Further preservation could be obtained by addition of sodium metabisulphite. In conclusion, Lactic acid fermentation using L. plantarum is a novel method of producing Lacto pickles from Zapallo OFSP, with 93.97% β-carotene retention and adequate shelf life.