Protein isolate 1 (PI1) and protein isolate 2 (PI2) were prepared from industrially produced sunflower meal by using isoelectric and ethanol precipitation respectively. The water absorption capacity of PI1 was 6 times higher than that of PI2 and was significantly reduced by the presence of 0.03 M and 0.25 M NaCl. Oil absorption capacity of both protein isolates was not influenced by NaCl supplementation. Foam capacity of PI1 and PI2 was pH-dependent. While the foam capacity of both isolates was improved by either 0.03 M or 0.25 M NaCl, the foam stability was negatively influenced by the addition of NaCl at all pH values with except for pH 4. Emulsifying activity of PI1 and PI2 was lowest at pH 4. The emulsions exhibited relatively high stability (> 90%) under all studied conditions. Knowledge of the influence of pH and boundary concentrations of NaCl on the functionality of sunflower meal protein isolates could be beneficial for their future potential application in food industry. 

A shelf-life study on cupua¸cu nectar (Theobroma grandiflorum) was carried out in two parts. Part I studied the microbial stability of the regular nectar (batch R) and the same nectar fortified with synthetic ascorbic acid (AA) (batch F), pasteurized at 90 ◦C for 3 min and hot filled in glass bottles. Total Plate Count (TPC), yeast and molds as well as pH, total soluble solids (TSS), titratable acidity and hidroxymethylfurfural (HMF) were followed along 43 storage days at 4, 25 and 35 ◦C. At the end of the storage period neither TPC nor molds or yeast had recovered the initial loads observed before pasteurization, for both R and F batches. Right after pasteurization, acidity increased slightly, pH decreased from 3.52 to 3.3, and TSS increased from 18.7 to 19.0 ◦Brix, with all stabilizing afterwards. Part II evaluated ascorbic (AA) and dehydroascorbic (DHAA) acids’ stabilization in the two batches, R and F, and dissolved oxygen (DO) was monitored. Both batches were stored at the same temperatures as in Part I for two months. For batch R, the AA degradation results followed a reversible first order reaction (EaAA(R) =-34±6 kJ/mol, k AA(R)25◦C =0.006±0.003 days−1 , C0AA(R)=0.92±0.01 and C ∞AA(R)= 0.43±0.19). For the (F) nectar, the experimental data fitted a first order model well (EaAA(F )=30±17 kJ/mol, k AA(F )25◦C =0.0016±0.0004 days−1 ). DO was modeled as a fractional conversion model (EaDO= 67±17 kJ/mol, kDO25◦C = 1.94±0.94 days−1 , C0DO=0.97±0.03 and C ∞DO= 0.55±0.01). For both nectars, storage at environmental temperatures was preferred (AA retention above 80%) to refrigeration, due to the slower rate of diffusion of DO at lower temperatures. 

Two different pre-treatments were applied to grapes prior to drying in a mixed mode solar dryer. Grapes were blanched in water and in a 0.1% sunflower oil water emulsion, both at 99◦C and for approximately 15 seconds. Several models were tested to fit the experimental data of drying curves but the normalized Newton model gave the best fit results. Samples blanched in hot water or in the 0.1% edible oil emulsion had faster drying rates than untreated samples. Contrary to what was expected, pre-treating with the 0.1% edible oil emulsion did not increase the drying rate to a higher extent than blanching. Pre-treatments did not give a noteworthy difference in the total drying time. However, they had an important role in accelerating initial drying rates, thus preventing moulds and bacterial growth and consequently increasing farmers’ income

This paper describes the author’s experience over the last several years of implementing an alternative Food Chemistry laboratory practical model for a group of third-year BSc Nutraceuticals students. The initial main objectives were to prepare students for the more independent final-year research project; to incorporate innovative approaches to feedback; and to integrate key employability skills into the curriculum. These were achieved through building the skills required to ultimately allow students working in groups to research, design and run a laboratory for their class. The first year of the project involved innovative approaches to feedback, including weekly feedback sessions, report checklists and audio feedback podcasts. Student evaluation after one year suggested the case group felt more prepared for final-year research projects and work placement owing to the redesign of the laboratory assessment. This, together with general positive feedback across several indicators, was proof of concept, and was a foundation for an improved model. The improvements related to the organisation and management of the project, but the same pedagogical approach has been retained. The second year saw the introduction of a more rigorous and easier to manage peer evaluation through use of the online Comprehensive Assessment for Team-Member Effectiveness (CATME) tool. The most recent revision has included a Project Wiki hosted on Blackboard™to facilitate the organisation, communication, assessment and feedback of student-generated resources. More recently, the final-year students who had participated in the peer-teaching Food Chemistry labs when in third year have been evaluated. This evaluation took place following their research projects, and suggests that the peer-teaching model better prepared them for these activities, compared to traditional laboratories.

This study investigated the ability of Lactobacillus plantarum strains (NGL5 and NGL7) and Candida tropicalis (NGY1) previously identified from akamu-a Nigerian fermented maize food with probiotic L. plantarum LpTx and Saccharomyces boulardii SB20 to ferment ground maize slurries based on pH, acidity, microbial biomass, levels of sugars and organic acids, and their antimicrobial activity against Salmonella enterica serovar Enteritidis NCTC 5188, Escherichia coli NCTC 11560, Bacillus cereus NCIMB 11925, Staphylococcus aureus NCTC 3750 and Listeria monocytogenes NCTC 7973 using an agar spot assay. L. plantarum strains either as single or mixed starter cultures with the yeasts had growth rates ≥0.15 h−1 , with pH significantly (p≤0.05) decreased to ≤3.93 after 12 h and then to ≤3.52 after 72 h and lactic acid >84 mmol L−1 . The yeasts had growth rates ≥0.18 h−1 but pH was ≥4.57 with lactic acid levels ≤20.23 mmol L−1 after 72 h in the single culture fermentation. There was no inhibition in modified MRS agar: 0.2% glucose and 0.2% glucose without Tween 80. Inhibition halos in MRS agar varied from 10.6 to 23.9 mm. S. bourladii was more inhibitory towards L. monocytogenes (8.6 mm) and B. cereus (5.4 mm ) than was C. tropicalis (1.1 and 3.3 mm for L. monocytogenes NCTC 7973 and B. cereus NCIMB 11925 respectively) (0.9 mm) in malt extract agar. This study showed that C. tropicalis was less inhibitory to the pathogens while antimicrobial activities of the L. plantarum strains were mainly due to acidity and the L. plantarum strains either as single or mixed cultures with the yeasts demonstrated strong fermentation ability, with significant decrease in pH which is vital in the choice of starter for product safety

The purpose of this study was to determine the most powerful aroma-active compounds of olive oils obtained from Ayvalik (AYV), Gemlik (GEM) and Memecik (MEM) cultivars harvested in 2011, using gas chromatography-mass spectrometry-olfactometry (GC-MS-O). Simultaneous distillation and extraction (SDE) with dichloromethane was used for extraction of volatile components. The aromaactive compounds of olive oils were evaluated by aroma extract dilution analysis (AEDA). A total of 14, 12 and 12 aroma-active compounds within the range of ≥64–1024 flavor dilution (FD) factors were detected in aromatic extracts of olive oils obtained from AYV, GEM and MEM cvs., respectively. The compounds having the highest FD factor (1024) were (Z)-3-hexenol (cut grass, herbal) and βsesquiphellandrene (floral) for AYV oil and (Z)-3-hexenyl acetate (fruity) for MEM oil. Among these compounds, terpenes were the overwhelmingly largest aroma-active components followed by aldehydes. 

Cassava (Manihot esculenta Crantz) and cowpea (Vigna unguiculata L. Walp) were processed into flours and used to substitute wheat flour for preparation of cookies. The chemical, including proximate composition and anti-nutritional factors, and functional and pasting properties of the blends were determined. Cookies were produced from the blends with 100% wheat flour as a control. The antinutritional factors, physical properties and organoleptic attributes of the cookies were evaluated. An increase in the level of cassava flour substitution resulted in a decrease in the protein content of the composite flour. However, addition of cowpea flour resulted in an increase in the protein content. There were significant (p<0.05) reductions in the studied anti-nutritional factors after baking. Cookies from composite flours were not significantly (p>0.05) different from the control in overall acceptability. This indicates the feasibility of producing nutritious cookies with desirable organoleptic qualities from cassava, wheat and cowpea composite flour.

Beef-in-sauce catering meals under blast-cooling have been investigated in a research project which aims at quantitative HACCP (hazard analysis critical control point). In view of its prospective coupling to a predictive microbiology model proposed in the project, zero-order spatial dependence has proved to suitably predict meal temperatures in response to temperature variations in the cooling air. This approach has modelled heat transfer rates via the a priori unknown convective coefficient hc which is allowed to vary due to uncertainty and variability in the actual modus operandi of the chosen case study hospital kitchen. Implemented in MS Excel®, the numerical procedure has successfully combined the 4
th order Runge-Kutta method, to solve the governing equation, with non-linear optimization, via the built-in Solver, to determine the coefficient hc. In this work, the coefficient hc was assessed for 119 distinct recently-cooked meal samples whose temperature-time profiles were recorded in situ after 17 technical visits to the hospital kitchen over a year. The average value and standard deviation results were hc = 12.0 ± 4.1 W m−2 K −1 , whilst the lowest values (associated with the worst cooling scenarios) were about hc ≈ 6.0 W m−2 K −1 .Convective heat transfer

Yerba mate infusion is widely consumed in Argentina, Brazil and Paraguay. One of the processing steps used in Argentina is aging. The following three methods were used to age yerba mate: 1) air humidity and temperature-controlled aging; 2) temperature-controlled aging and 3) no control. The aim of this research was to determine the physicochemical and sensory attribute differences when yerba mate was aged using these three methods. The concentration of caffeine, glucose, fructose, maltose and phenolic compounds and pH diminished in all three aging methods but by different percentages. The sensory attributes did not exhibit uniform behaviour. Astringency remained constant in the first method and diminished in the other two. Bitterness increased in all three methods but by different percentages. Sweetness diminished in all three methods. Notably few correlations were determined between physicochemical and sensory attributes.

In European Higher Education, learning outcomes and competences have been used sometimes with different meanings and sometimes with the same meaning. But both terms have been more commonly used to refer to knowledge, understanding and abilities a student must demonstrate at the end of a learning experience. Their use is a consequence of the paradigm shift of the Bologna Process to a learner centered education environment. The definition of standards of competences (or learning outcomes) for the PhD degree is thus a need for the quality assurance of this degree. In this work, subject-specific and generic competences for the PhD in Food Science and Technology and their alignment with the European Qualifications Framework (EQF) level descriptors for quality assurance purposes have been identified.