Solid lipid microparticles produced with a mixture of cupuacu butter and stearic acid were used to microencapsulate a commercial casein hydrolysate (Hyprol 8052). The composition of the lipid matrix used for the production of the lipid microparticles was chosen according to data on the wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC) of bulk lipid mixtures, which indicated that the presence of 10 % cupuacu butter was sufficient to significantly change the crystalline arrangement of pure stearic acid. Preliminary tests indicated that a minimum proportion of 4 % of surfactant (polysorbate 80) was necessary to produce empty spherical lipid particles with average diameters below 10 mm. The lipid microparticles were produced using 20 % cupuacu butter and 80 % stearic acid and then stabilized with 4 % of polysorbate 80, exhibiting an encapsulation efficiency of approximately 74 % of the casein hydrolysate. The melting temperature of the casein hydrolysate-loaded lipid microparticles was detected at 65.2 °C, demonstrating that the particles were solid at room temperature as expected and indicating that the incorporation of peptides had not affected their thermal behavior. After 25 days of storage, however, there was a release of approximately 30 % of the initial amount of encapsulated casein hydrolysate. This release was not thought to have been caused by the liberation of encapsulated casein hydrolysate. Instead, it was attributed to the possible desorption of the adsorbed peptides present on the surface of the lipid microparticles.

Optimal conditions for the industrial extraction of total polyphenols from maté (Ilex paraguariensis) were determined using response surface methodology, with two independent variables: ethanol percentage of the extraction solution and liquid to solid ratio. Response variables were total polyphenol content, antioxidant capacity, concentration of total polyphenols and caffeine content.The optimal conditions found were a liquid to solid ratio from 8 - 9 w w-1 and ethanol percentage of the extraction solution from 30 -50 % w w-1. Under these conditions the main predicted values corresponding to leaf extracts were 40 μg chlorogenic acid equivalents mL-1 of original extract, 13 g chlorogenic acid equivalents per 100 g dry matter for total polyphenol content, 22 g Trolox equivalents and 15.5 g ascorbic acid equivalents per 100 g dry matter for antioxidant capacity. The total polyphenol content of twig extracts was 36% lower than that in the leaf extracts.

The objective of this study was to propose a multi-criteria optimization and decision-making technique to solve food engineering problems. This technique was demonstrated using experimental data obtained on osmotic dehydration of carrot cubes in a sodium chloride solution. The Aggregating Functions Approach, the Adaptive Random Search Algorithm, and the Penalty Functions Approach were used in this study to compute the initial set of non-dominated or Pareto-optimal solutions. Multiple non-linear regression analysis was performed on a set of experimental data in order to obtain particular multi-objective functions (responses), namely water loss, solute gain, rehydration ratio, three different colour criteria of rehydrated product, and sensory evaluation (organoleptic quality). Two multi-criteria decision-making approaches, the Analytic Hierarchy Process (AHP) and the Tabular Method (TM), were used simultaneously to choose the best alternative among the set of non-dominated solutions. The multi-criteria optimization and decision-making technique proposed in this study can facilitate the assessment of criteria weights, giving rise to a fairer, more consistent, and adequate final compromised solution or food process. This technique can be useful to food scientists in research and education, as well as to engineers involved in the improvement of a variety of food engineering processes.

The objective of this research was to study the effects of modified atmosphere, associated with masterpack transport packaging, and refrigerated storage time on the quality characteristics of pork loin cuts. Cuts of pork loin were packaged in trays, covered with poly(vinyl chloride) film. The trays were placed in a masterpack (MP), containing three gas compositions:  A) 75% O2 : 25% CO2, B) 50% O2 : 50% CO2 or C) 100% CO2, and stored at 2 °C. Samples were taken after 1, 8, 15, and 22 days of storage, and evaluated for numerous shelf life traits. The development of Psychrotrophic aerobic bacteria and Pseudomonas spp. was found from the 15th day of storage. There was a significant treatment effect for some of the considered parameters, such as pH (P < 0.05) and color [L* (P < 0.07), a* (P < 0.07) and b* (P < 0.01)]. There was a significant interaction (P < 0.01) for the TBARS values. It can be concluded, from the microbiological point of view, that the use of modified atmospheres containing 25% to 100% CO2 promotes the conservation of meat for up to 15 days of storage under refrigeration. From the point of view of color, atmospheres containing 75% O2 : 25% CO2 and 50% O2 : 50% CO2 ensure the color of packaged pork meat when stored at 2 °C for up to 15 days. From the point of view of lipid oxidation, packages with 100% CO2 are recommended for storage periods of more than 15 days, whereas those with 75% O2 : 25% CO2 are recommended for storage periods of up to 8 days.

Honey quality is clearly defined in the EU Directive 2001/110/EC, and by Codex Alimentarius (Codex Stan 12-1981) and the International Honey Commission (IHC, 2002). Our investigation aimed to characterize the physicochemical properties of honey produced on a small island, Gozo which is situated near Malta.  Ten randomly collected honey samples were analysed for moisture content, pH, free acidity, water insoluble content, hydroxymethylfurfural (HMF) content and total phenolic compounds.  Moisture content, pH, free acidity, water insoluble content, and HMF content were within the range specified in standards but the electrical conductivity was generally higher than 0.800 mS cm-1. This may be the result of the relatively high atmospheric and soil salinity on this small island. All the samples analysed were within the 40 mg kg-1 HMF limit, which is an indicator of honey quality. The total phenolic compounds, which represent some of the constituents derived from the nectar and pollen obtained during foraging, ranged between 236.555 and 294.209 GAE kg-1 honey. Principal Component Analysis showed the properties of polyfloral honey samples obtained from the southern part of the island to be different from those obtained from the northern part.

The objective of this study was to propose a multi-criteria optimization and decision-making technique to solve food engineering problems. This technique was demonstrated using experimental data obtained on osmotic dehydration of carrot cubes in a sodium chloride solution. The Aggregating Functions Approach, the Adaptive Random Search Algorithm, and the Penalty Functions Approach were used in this study to compute the initial set of non-dominated or Pareto-optimal solutions. Multiple non-linear regression analysis was performed on a set of experimental data in order to obtain particular multi-objective functions (responses), namely water loss, solute gain, rehydration ratio, three different colour criteria of rehydrated product, and sensory evaluation (organoleptic quality). Two multi-criteria decision-making approaches, the Analytic Hierarchy Process (AHP) and the Tabular Method (TM), were used simultaneously to choose the best alternative among the set of non-dominated solutions. The multi-criteria optimization and decision-making technique proposed in this study can facilitate the assessment of criteria weights, giving rise to a fairer, more consistent, and adequate final compromised solution or food process. This technique can be useful to food scientists in research and education, as well as to engineers involved in the improvement of a variety of food engineering processes.

The quality of baked products is the complex, multidimensional result of a recipe, and a controlled heating process to produce the desired final properties such as taste, colour, shape, structure and density. The process of baking a sponge cake in a convective oven at different air temperatures (160-180-220 °C) leading to the same loss of mass was considered in this study. A special mould was used which allowed unidirectional heat transfer in the batter. Instrumentation was developed specifically for online measurement of weight loss, height variation and transient temperature profile and pressure in the product. This method was based on measuring heat fluxes (commercial sensors) to account for differences in product expansion and colour. In addition, measurement of height with a camera was coupled to the product mass to calculate changes in density over time. Finally, combining this information with more traditional measurements gave a better understanding of heat and mass transfer phenomena occurring during baking.

The aim of this research was to study the sensorial acceptance of a fortified food containing different minerals (calcium, magnesium and iron) and to determine the actual quantities present (bioaccessibility) when extracted in maté. A sensorial analysis was performed to compare sensorial quality of fortified and non-fortified maté. Although panelists identified differences between the fortified and non-fortified maté, only 3% of them commented on an unpleasant flavor. Sequential extraction assays were performed simulating maté consumption under laboratory conditions. Profile concentration diminished sharply after the second extraction. Magnesium was found to be completely extracted in the first 500 mL. Calcium and Iron were extracted in a very low percentage (29% and 25%, respectively). The outlet rate of the minerals was fitted to two models, and a good fitness (p < 0:001) in all cases was obtained.

The effects of organic material and biofilm formation on the efficacy of Suma Tab D4 chlorine tablets and Suma Bac D10 quaternary ammonium compound (QAC) against Listeria monocytogenes was determined in suspension and on stainless steel and polystyrene surfaces according to standard disinfectant test methodology. Exposure to 200 and 740 mg L-1 QAC and to 150 mg L-1 active chlorine resulted in a > 5.0 log10 CFU mL-1 and > 5.0 log10 CFU/coupon reduction of six L. monocytogenes strains within one minute, in suspension tests, and on stainless steel surfaces, respectively. Additionally, there was a reduction by as much as 5 log10 CFU/coupon or 5 log10 CFU/well of reference strains EGDe and Scott A biofilms within five minutes on stainless steel and polystyrene surfaces. Organic material, added as bovine serum albumin at 0.3% (w/v) completely prevented the inactivation of L. monocytogenes in 150 mg L-1 chlorine, while reductions of only 0.6 +- 0.1 log10 CFU mL-1 were recorded in the presence of UHT milk at 3% (v/v). In contrast, reductions of 5 log10 CFU mL-1 were recorded within one minute on exposure to 740 mg L-1 QAC in the presence of 0.3% (w/v) bovine serum albumin and within two minutes in the presence of 20 % (v/v) UHT milk. Although Suma D4 chlorine tablets and Suma Bac D10 QAC are effective listericidal agents at recommended concentrations, Suma Tab D4 chlorine efficacy against L. monocytogenes is impaired by the presence of low concentrations of organic material, while Suma Bac D10 QAC maintains its listericidal activity in high organic loads.